Control4® DIN-Rail 8-Channel Adaptive Phase Dimmer V2

Features
Specifications

The Control4® 48V Bus Power Supply is intended for use in a Control4 system. This device provides power for the Configurable Wired Keypads (C4-KCB, C4-SKCB, and C4-SKCB2), the Bus Ethernet Gateway (C4-DIN-BEG), and the Dry Contact Input Module (C4-DCIM). It can also be used to power the Wireless Configurable Keypads (C4-KC120/277, C4-KC240, and C4-SKC) in a mixed wired/wireless keypad installation. This product is used in conjunction with the Control4® Bus Ethernet Gateway (C4-DIN-BEG-V2) to allow keypads on the RS-485 bus to communicate with a Control4 controller and the Centralized Lighting system.

Controls up to eight loads and supports a variety of load types
Each channel can be set to different dimming modes including Switch mode, Forward Phase mode, Reverse Phase mode, and Autodetect mode
Channel buttons allow for toggling on/off or ramping up/down a load
Channel Status LEDs indicate whether a load is on, off, or in short-circuit fault
Module Override button allows toggling between the module override scene and all channels off or setting the module override scene to current channel levels
Module Status LED indicates if module power is on with normal operation, off, or in thermal overload
Link/Activity LED indicates system link status, communication activity, or firmware update status
Reset button can be used for factory default or network configuration settings
Auxiliary override connection allows a standard line-voltage toggle switch to control the attached lights before the control system is installed or in case the controller malfunctions
Module can be installed in either a Control4 5-Slot or 2-Slot Panel or in a third-party DIN-Rail Panel
California Title 20 compliant (see ctrl4.co/title20 for more information on Title 20 / Title 24 compliance)