🛠️ How to Set Up Your Hikvision Intercom Touch Panels

Quick Configuration Guide by HAP.sg

Follow these simple steps to configure your Hikvision indoor touch panels, ensuring your intercom system works smoothly and indoor stations ring correctly when the doorbell is pressed.

Step-by-Step Setup

✅ Step 1: On the main indoor touch panel, go to Settings → Configuration.

✅ Step 2: Enter the admin password when prompted.

✅ Step 3: Verify that Indoor Station Type is set to Indoor Station (not extension).

✅ Step 4: Select the third tab on the top — this is Device Management.

✅ Step 5: Select Main Door Station from the list and assign it so the main indoor panel will ring when the doorbell is pressed.

✅ Step 6: On each extension indoor touch panel, repeat the process:

Go to Settings → Configuration → enter the admin password.

✅ Step 7: Verify that Indoor Station Type is set to Indoor Extension.

✅ Step 8: Make sure a Registration Password is configured for the extension panel (this secures device registration).

✅ Step 9: Repeat Steps 6 to 8 for all other indoor extension panels in your system.

🎥 Tutorial Video

💡 Tips:

• Setting the correct indoor station type ensures calls and notifications route properly.
• The registration password helps secure your system and prevent unauthorized devices from registering.
• After setup, test by ringing the main door station and confirming all configured touch panels ring accordingly.